One way to make writing more fun is to use a fountain pen. A standard fountain pen has an iridium ball on the tip that allows the pen to write consistent lines at any angle. This is great, except when you want a pen that reminds you of the signers of the US Constitution.
For that you need a stub nib.
Today I will show you how to modify a cheap fountain pen to make it into a stub nib. I would like to emphasize “cheap” because it would be a bad idea to modify an expensive pen in this way unless you are already confident in your results.
Let’s start with a Jinhao 599. Some will criticize this pen as a cheap knock-off of the Lamy Safari. While there is a certain (ahem) family resemblance there are a few features of this pen that make it stand out for our purposes.
- This tip of the 599 is traditional in the way that the nib slides into the section friction-fit with the ink feed. The Safari has a clip-type nib that would be a little more complicated to modify and adjust
- The 599 takes a standard international cartridge and includes a piston converter. This alone makes the pen more convenient than the Safari with its proprietary cartridges because it’s cheap to fill, whether with cartridges or liquid ink.
- This pen itself is cheap. What I mean by that is that this pen is cheaper than a decent rollerball. I ordered this pen for $1.70 from China. That means that if you ruin the pen forever, you still have 13 more chances before you match the cost of ruining a Safari.
But it’s actually not that difficult.
To start, cut off the iridium ball at the tip:
I have used diagonal cutters, lineman’s pliers, and needlenose pliers. This will leave a sharp edge that would cut your paper or fingers. This is not ideal.
Next grind the tip flat across. I grind these by hand on diamond plates but you could also use a bench grinder for this stage or coarse sandpaper.
After getting the tip flat, move to a finer grit of sharpening stone or sandpaper. Hold the pen as if you were writing and grind in circular or figure-eight motions.
The goal is to smooth out the edges that might catch on the paper. Move from coarse to fine grit until you are polishing the tip.
Once it is polished, ink it up and test it. If you still feel scratching determine whether it is an outside edge or misaligned tines. If the tines are misaligned, the inside edge will catch on the paper. Adjust the tines with your fingers so they are inline.
This is what they should look like, straight across.
Check how the ink is flowing. If it’s not getting enough ink then it will continue to scratch. If you need more ink, open up the space between the tines by pressing the tip against a flat surface until they spread.
Try not to go too far because this isn’t easy to reverse.
Tweak the pen until you like how it’s writing, opening the tines, aligning the tines, and polishing any sharp edges.
Then go write something.
Regards
Yo, how did you get this to work?
I installed wordpress. Download here. It was relatively painless.